Link speed and duplex settings
NOTE:
This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most
situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings
might prevent the product from communicating with other network devices. If you need to make
changes, use the product control panel.
NOTE:
The setting must match with the network product to which you are connecting (a network hub,
switch, gateway, router, or computer).
NOTE:
Making changes to these settings causes the product to turn off and then on. Make changes
only when the product is idle.
1.
From the Home screen on the product control panel, touch the Setup button.
2.
Scroll to and touch the
Network Setup
menu.
3.
Touch the
Link Speed
menu.
4.
Select one of the following options.
Setting
Description
Automatic
The print server automatically configures itself for the highest link speed and
communication mode allowed on the network.
10T Full
10 Mbps, full-duplex operation
10T Half
10 megabytes per second (Mbps), half-duplex operation
100TX Full
100 Mbps, full-duplex operation
100TX Half
100 Mbps, half-duplex operation
1000T Full
1000 Mbps, full-duplex operation
5.
Touch the
OK
button. The product turns off and then on.
ENWW
Configure IP network settings
147